1) According to the workload, the dust removal operation should be carried out on the inside of the machine regularly to ensure the normal heat dissipation of the motor.
2) Regularly dedust the pusher track to ensure smooth running of the push table.
3) Check the belt regularly and find that the wear should be replaced in time.
4) Regularly fill the lubricating parts of the fuselage to ensure the stability and quietness of the equipment operation.
Sliding table saw operation instructions
1. Before starting the machine, you must carefully check the saw blade pad and the compression nut and the screws at all parts. If it is loose, it should be tightened in time. When installing the saw blade, pay attention to the cutting direction and irreversible.
2. Precision table saws do not allow the saw blade to work without a protective cover.
3. When hand feeding, be sure to hold the wood close to the workbench and position the plate. The hand should not be too close to the saw blade. It is strictly forbidden to process wood that cannot be controlled by the hand.
4. Before processing, the wood should first check whether the wood is sawed at the place where there are nails, sandstone, joints, etc., in order to prevent damage to the saw blade and the joints flying out and hurting people.
5. The precision push table saw can't stand in the cutting direction, and the operator should pay attention to safety when collecting wood.
6. When cleaning the machine, wiping the lubricant, removing the saw blade and removing the sawdust, the power must be turned off.
7. When fault happens, the power should be cut off immediately, and the operation should be stopped. The repair and adjustment should be carried out by a special person, and the machine tool is not allowed to operate with faults.
